Curved Walls

*Note: curved walls use construction points for input users must make sure that °snap is not selected to be able to pick the proper points on the curved wall*

When click on curved wall it will provide 2 input methods: or

1st Input method: 3 points along curve: start, midpoint, end (curve goes thru the midpoint) When picking a construction point select the origin using the mouse key. This allows offset and users can move until the final location and place as many constructions points as wanted and/ or needed. Using the esc key will then exit the command

2nd input method: start, centre (radius), end- on this input it allows you to move the mouse and see how the wall curves.

* Curved wall input will create a perfectly smooth curve and any straight item (window, door, wall opening, ledger) can not be added when it is smooth. This means that the wall will need to be segmented* the smaller the number a user chooses the greater the amount of segments there will be.

1. User is able to choose to have equal segments (5,8,10, etc.)
2. User is able to set max length for example set the length as 30 (inches) put in a 2 ft opening and it may be divided into 2 or 8 pieces as long as they are 30 inches or less